top of page
NEW MEXICO, USA
Low bolt load
Seals lightly bolted and flat-face flanges where hard gaskets cannot reach seating stress.
Blow-out resistant
The steel core holds the elastomer in place under pressure surges and water hammer.
No cold flow
The core limits compression, so bolt load is retained and re-torquing is reduced.
Fast installation
Rigid, flat gasket that does not fold or tear when slid between flanges.
CONSTRUCTION
A steel core with a bonded elastomer seal
-
Steel core: carbon steel [Zinc-Plated] or stainless steel 304 / 316
-
Sealing element: EPDM or NBR, vulcanised to the core
-
Profiles: full face (with bolt holes) or ring inside the bolt circle
-
Traceability: batch number on every gasket
ELASTOMERS
Pick the elastomer for the medium
Elastomer
Temperature range
Suitable for
Not suitable for
EPDM
−40°C to +120°C
Potable and raw water, wastewater, seawater, hot water, glycol
Oils, fuels, hydrocarbons
NBR (nitrile)
−30°C to +100°C
Mineral oils, fuels, hydraulic fluids, natural gas
Ozone and weathering, steam, ketones
Neoprene
−30°C to +100°C
Water, ozone, mild chemicals, and moderate oil exposure.
Strong acids, ketones and hydrocarbons.
FKM Viton
−20°C to +200°C
Oils, fuels, hydrocarbons, acids, chemicals, ozone, and HT Apps.
Ketones, ethers and certain amines.
SPECIFICATIONS
Technical data
Custom sizes and drillings made to drawing.
Nominal sizes
NPS 2" to 100" / DN 50 to 2500
Flange drillings
ASME B16.5, ASME B16.47, EN 1092-1
Maximum pressure
580 psi / 40 bar
Thickness
3.0mm or 6.4mm
Elastomer hardness
70 ± 5 Shore A
Gasket design data (EN 13555)
[AVAILABLE ON REQUEST, ONCE TESTED]
Drinking water approval
FDA Certificate
Downloads
PDF . CATALOG​
Rubber-Steel Gasket Datasheet
PDF . GUIDE​
RSG Installation Guide
PDF . TABLE​
Gasket Torque Table
bottom of page